D7net Mini Sh3LL v1
| Current File : //libx32/../share/snapd/../locale/../doc/libpcre3/../iptables/html/packet-filtering-HOWTO-9.html |
<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 3.2 Final//EN">
<HTML>
<HEAD>
<META NAME="GENERATOR" CONTENT="LinuxDoc-Tools 0.9.73">
<TITLE>Linux 2.4 Packet Filtering HOWTO: Mixing NAT and Packet Filtering</TITLE>
<LINK HREF="packet-filtering-HOWTO-10.html" REL=next>
<LINK HREF="packet-filtering-HOWTO-8.html" REL=previous>
<LINK HREF="packet-filtering-HOWTO.html#toc9" REL=contents>
</HEAD>
<BODY>
<A HREF="packet-filtering-HOWTO-10.html">Next</A>
<A HREF="packet-filtering-HOWTO-8.html">Previous</A>
<A HREF="packet-filtering-HOWTO.html#toc9">Contents</A>
<HR>
<H2><A NAME="s9">9.</A> <A HREF="packet-filtering-HOWTO.html#toc9">Mixing NAT and Packet Filtering</A></H2>
<P>It's common to want to do Network Address Translation (see the NAT
HOWTO) and packet filtering. The good news is that they mix extremely
well.</P>
<P>You design your packet filtering completely ignoring any NAT you
are doing. The sources and destinations seen by the packet filter
will be the `real' sources and destinations. For example, if you are
doing DNAT to send any connections to 1.2.3.4 port 80 through to
10.1.1.1 port 8080, the packet filter would see packets going to
10.1.1.1 port 8080 (the real destination), not 1.2.3.4 port 80.
Similarly, you can ignore masquerading: packets will seem to come from
their real internal IP addresses (say 10.1.1.1), and replies will seem
to go back there.</P>
<P>You can use the `state' match extension without making the packet
filter do any extra work, since NAT requires connection tracking
anyway. To enhance the simple masquerading example in the NAT HOWTO
to disallow any new connections from coming in the ppp0 interface, you
would do this:</P>
<P>
<BLOCKQUOTE><CODE>
<PRE>
# Masquerade out ppp0
iptables -t nat -A POSTROUTING -o ppp0 -j MASQUERADE
# Disallow NEW and INVALID incoming or forwarded packets from ppp0.
iptables -A INPUT -i ppp0 -m state --state NEW,INVALID -j DROP
iptables -A FORWARD -i ppp0 -m state --state NEW,INVALID -j DROP
# Turn on IP forwarding
echo 1 > /proc/sys/net/ipv4/ip_forward
</PRE>
</CODE></BLOCKQUOTE>
</P>
<HR>
<A HREF="packet-filtering-HOWTO-10.html">Next</A>
<A HREF="packet-filtering-HOWTO-8.html">Previous</A>
<A HREF="packet-filtering-HOWTO.html#toc9">Contents</A>
</BODY>
</HTML>
AnonSec - 2021 | Recode By D7net